Safety Regulations - Corghi ARTIGLIO 500 Manuel D'utilisation

The customer must provide an air cut-off valve upstream of the air treatment and regulator
device supplied with the machine B fig. 6.

SAFETY REGULATIONS

The equipment is intended for professional use only.
WARNING
Only one operator may work on the equipment at a time.
WARNING
Failure to comply with the instructions and danger warnings may cause serious injury
to operators and to others in the vicinity. Before powering up the machine, read and
ensure you understand all the danger, warning and attention notices in this manual.
This machine must be used only by qualified and authorised personnel. A qualified op-
erator is construed as a person who has read and understood the manufacturer's instruc-
tions, is suitably trained, and is conversant with safety and adjustment procedures to be
adhered to during operations. Operators must not use the machine under the influence
of alcohol or drugs which may affect their capacity.
The operator must, in all cases:
- Be able to read and understand all the information in this manual.
- Have a thorough knowledge of the capabilities of this machine.
- Keep unauthorised persons well clear of the area of operations.
- Make sure the machine has been installed in compliance with all relevant regulations
and legislation.
- Make sure that all machine operators are suitably trained, that they are capable of using
the equipment correctly and that they are adequately supervised.
- Never leave nuts, bolts, tools or other equipment on the equipment; they may become
entrapped between moving parts.
- Not touch power lines or the inside of electric motors or other electrical equipment
until the power supply has been disconnected.
- Read this manual carefully and learn how to use the machine correctly and safely.
- Always keep this operator's manual in an easily accessible place and consult it whenever
necessary.
WARNING
Do not remove or deface the Danger, Warning or Instruction decals. Replace any
missing or illegible decals. If one or more decals have been detached or damaged,
replacements can be obtained from your nearest dealer.
- When using and carrying out maintenance on the machine, observe the standardised
industrial accident prevention regulations for high voltages.
- Unauthorised alterations or changes to the machine relieve the constructor of all liability
for any consequent damage or accidents. Specifically, tampering with or removing the
safety devices is a breach of the regulations for safety in the workplace.
Operator's manual Artiglio 500
GB
51