Practical Installation Diagramspage; Technical Data; Three-Phase Installation - Riello RiCLOUD Notice Installateur Et Utilisateur

2.2 Practical installation
diagramspage
See practical installation diagrams on
page 192.
2.3

Technical Data

See page 210.
2.4

Three-phase installation

Preparation
Before installing the device
Check that the
compatible with the boiler (see boiler
installer manual).
The wireless RiCLOUD thermostat
can be installed anywhere, however
the most suitable place should
be chosen taking into account the
following:
− Avoid draughts (A).
− Do not install above sources of
heat (B).
− Avoid direct sunlight (C).
− Position at the appropriate
height (D).
A
C
thermostat is
B
1,5m
D
Wireless installation
require any wiring, making the
process very simple.
RiCLOUD thermostat can also be
installed with wiring, to replace
any existing thermostat, provided
compatibility is checked in advance.
Before installing the boiler control
unit (WiFi Box), disconnect the boiler
from the power supply.
Installation
The following tools are required:
− Phillips screwdriver
− Small slotted screwdriver
− Pliers and wire strippers
Installing RiCLOUD
Remove RiCLOUD from its base;
Fix RiCLOUD base to the wall or
electrical box
provided, use the optics level in the
plastic wrapping to install RiCLOUD
horizontally.
Using screws
PROVIDED may compromise the correct
closure of the plastic. Make sure that
the screw head is correctly inserted in
the hole.
58
does not
using the screws
other than those