1
GENERAL INFORMATION
1.1
General notices
Please read this manual before installing and using the device.
9
Risk of electric shock. This device should be installed by a qualified
professional and in line with the standards in force for electrical
installations. Always disconnect the power supply before installing.
9
Note to the installer:
− Most of the product parameters are factory set. If the device is activated
without a WiFi connection, the date and time should be set on the
thermostat as a minimum (this information is wiped every time the
batteries are removed and if not updated via the web). All other settings
– such as linking the receiver and the transmitter (for the WiFi Box),
usage mode and temperatures – are pre-configured.
9
These instructions must be read together with the sections of the boiler
manual regarding the room thermostat/boiler remote control. It is
recommended that the device be installed by qualified technicians.
9
RiCLOUD should be installed in the most accessible room for you as regards
controlling the room temperature (usually the living room).
9
As per the standards, RiCLOUD should be positioned 1.5 m from the floor to
make sure that you can easily read the display.
9
RiCLOUD is powered by 2 x AA batteries.
9
RiCLOUD must be kept away from sources of heat or air currents as these
may affect the accuracy of the readings from the incorporated room sensor.
9
Do not open RiCLOUD for any reason, unless to replace the batteries; it does
not require any maintenance to operate.
9
Do not press on the liquid crystal display glass as this may damage the
glass and cause problems with reading the display.
9
To clean the display, use a dry cloth only. Any seepage would damage the
liquid crystal display.
50