Troubleshooting; Information On Disposal And Recycling - Videotec MAXIMUS MVXT Manuel D'instructions

10 Troubleshooting

Contact an authorised support centre if
the problems persist or you have any other
issues that are not described here.
Read the product Manual A before
performing any operation.
PROBLEM After turning the device on,
the following is displayed on
the screen:
Address : 1 Address : 1
DE-ICE PROCEDURE DE-ICE PROCEDURE
IN PROGRESS... IN PROGRESS...
CAUSE Automatic preheating
procedure (De-Ice) in progress.
SOLUTION Wait until the end of the
pre-heating procedure. If the
ambient temperature is too low
the unit will remain blocked.
MNVCMVXTCAM_2121_EN
11 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
29