Cleaning The Product; Information On Disposal And Recycling - Videotec MAXIMUS MPX 2 Serie Manuel D'instructions

11.1.3 Cleaning the product

The outside surface of the product must
never be covered in more than 5 mm of
dust.
The cleaning of the product should be
carried out according to the instructions
in this chapter in order to prevent
accumulation of electrostatic charges.
The device should be cleaned using a damp cloth;
compressed air must not be used.
12 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
38
13 Troubleshooting
Before carrying out any type of
maintenance, read the "Safety rules"
chapter carefully in the product manual.
Contact an authorised support centre if
the problems persist or you have any other
issues that are not described here.
PROBLEM The product does not go on.
CAUSE Wiring error, blown fuse.
SOLUTION Make sure the connections are
correct. Check the continuity of
the fuses and replace them with
the indicated models should
they fail.
PROBLEM The shooting area do not
correspond to the selected
preset position.
CAUSE Loss of absolute position
reference point.
SOLUTION Reset the equipment by
switching off and on again.
PROBLEM The device does not move
during the start-up phase.
CAUSE The ambient temperature is too
low.
SOLUTION Wait until the end of the pre-
heating procedure. The following
message is displayed on the
web page: De-Ice procedure in
progress.
PROBLEM The illuminator reduces in
intensity or switches off.
CAUSE In high ambient temperatures,
the illuminator automatically
reduces the brightness flow.
SOLUTION Do not intervene. To reduce
the temperature, the system
will automatically restart the
illuminator.
MNVCMPXHDC_2222_EN