Accessories; Installation Of Ir-Proof Glass Kit; Cleaning; Cleaning The Window - Videotec NXW Manuel D'instructions

7 Accessories

7.1 Installation of IR-proof glass
kit
The kit is composed of an IR-proof glass pair and
a special air barrier flange that differs from the
standard one, which must be replaced.
Dismantle the front flange of the housing by
unscrewing the 4 screws using the hexagonal
wrench provided.
Insert the O-Ring gaskets (01), (02) in the respective
compartments in the flange. Position the glass pair
(03) in the specific compartment.
Correct orientation of the IR-proof glass.
Marking (04) identifies the surface of each
glass which must be turned outwards of
the housing.
01
04
03
Fig. 11
Position the new front flange on the body of the
housing, paying attention the gaskets are correctly
inserted in their compartments to avoid damaging
them. Tighten the 4 screws using the allen wrench
supplied.
MNVCNXW_2222_EN
02

8 Cleaning

8.1 Cleaning the window

We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
lenses.
Avoid ethyl alcohol, solvents,
hydrogenated hydrocarbide, strong acid
and alkali. Such products may irreparably
damage the surface.
9 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
9