Operation; Water Level; Controlling Whirlpool Action - Jacuzzi Luxury Serie Mode D'emploi

NOte: These instructions pertain to all bath products
manufactured by Jacuzzi Whirlpool Bath. Not all features
©
discussed in this instruction manual apply to all baths.
All baths manufactured by Jacuzzi
designed for "fill and drain," which means the bath should
be drained after each use and filled with fresh water by the
next bather. This is a health precaution, as these baths are
not designed to hold water continuously like pools or spas.
If you want a unit designed to continuously hold water, see
your Jacuzzi Whirlpool Bath dealer for the complete line of
©
whirlpool spas available.

Water LeVeL

Close the drain and fill the bath until water is at least 1 to 2"
(25 to 51 mm) above the highest jet (see water line indicated
in the illustration).
CautiON: Do not turn on the whirlpool system at any time
if the jets are not completely immersed in water. Do not
immerse the control panel by overfilling the bath. Running the
whirlpool system when there is insufficient water in the bath
could result in water spraying outside the bath area.
iMPOrtaNt: When exiting the bath, the water level will drop
below the jets which could result in water being sprayed out
of the unit. To prevent this, you must turn the unit off before
exiting the bath.

CONtrOLLiNg WhirLPOOL aCtiON

The whirlpool action in your bath, controlled manually and
electronically, is influenced by three factors: Direction of flow,
force of water, and force of air. Every bath manufactured by
Jacuzzi Whirlpool Bath that is equipped with fully adjustable
©
PowerPro jets, are manually adjustable for direction and
®
water force. Some baths have additional jets which can be
adjusted for direction only. Baths equipped with 2 speed
motors and electronic controls can also influence water force
and force of air.
DireCtiON: To change the direction of the water flow, swivel
the jet nozzle to the desired angle. The jets can be directed
individually toward any location on your body to provide a
hydromassage. The jets can also be adjusted so that they all
point in the same direction (clockwise or counterclockwise)
to circulate the water in a circular motion around the bath,
causing a total whirlpool effect.
Water FOrCe: The high volume, fully adjustable
PowerPro jets can be manually adjusted to control the
®
force of the water coming into the bath. For robust action,
increase the force of the flow by rotating the jet handles to
the left (counterclockwise). For a more gentle effect, rotate
the handles to the right (clockwise). Customize water force
by lowering water volume of 1 jet to increase water force in
another jet. In units with 2-speed motors the water force can
be increased or decreased using the electronic control. Never
run the whirlpool system with all the jets closed.
FOrCe OF air: Force of air is controlled electronically. Refer
to the Control Panel instructions for details in adjusting force
of air.
Jacuzzi Luxury Bath Series: Installation and Operation
©

OPeratiON

Whirlpool Bath are
©
*Fill to minimum 1 to 2"
above highest jet
typical Bath Fittings
Electronic
Control Panel
Fully adjustable jets
Suction
cover
Water Rainblow Fill
®
Spout (Optional)
*Selected units come with manual controls only.
Jets
Directionally
adjustable
Page 20
*1-2"
Water LeVeL
(highest jet)
*Magic Touch
®
Whirlpool, On-Off Switch
*Air Control
Knobs
Drain/overflow (Optional)
Fully
adjustable
K339000Y • April 2008