Operation - Jacuzzi Designer Directives D'installation & D'utilisation

OPERATION

Note: These instructions pertain to all bath products manufactured by Jacuzzi Whirlpool Bath. Not all features discussed in this
instruction pamphlet apply to all baths.
All baths manufactured by Jacuzzi Whirlpool Bath are designed for "fill and drain," which means the bath should be drained after each use and
filled with fresh water by the next bather. This is a health precaution, as these baths are not designed to hold water continuously like pools or
spas. If you want a unit designed to continuously hold water, see your Jacuzzi Whirlpool Bath dealer for the complete line of whirlpool spas
available.
Once the bath is installed, remove any residue or foreign materials left over from construction. Use turpentine or paint thinner to remove
stubborn stains, paint or tar. Other dirt can be cleaned off with a mild liquid detergent on a damp cloth. Scrape off plaster with a wooden or plastic
edge; do not use metal scrapers, wire brushes or other metal tools, as they will damage the bath's surface.
Water Level
Close the drain and fill the bath until water is at least 2" above the highest jet (see water line indicated in the illustration). Do not turn on the
whirlpool system at any time if the jets are not completely immersed in water. Running the whirlpool system when there is insufficient water
in the bath could result in water spraying outside the bath area. Running the whirlpool system without water will damage the recirculating pump.
IMPORTANT: When exiting the bath, the water level will drop below the spinning neck jets which could result in water being sprayed out of the
unit. To prevent this, you must turn unit off before exiting bath.
Aura, Fiore and Fontana
For shower use, turn the diverter handle counter clockwise, rotate the Water Rainbow flow control handle upward and remove the hand-held
shower from the vanity area. Then turn on the water using the hot and cold faucet handles. Before replacing the hand held shower, turn off
the water supply at the hot and cold faucet handles and turn the diverter valve handle clockwise (OFF).
During whirlpool operation, the second Water Rainbow in the corner of the bath will create a pleasurable waterfall effect; if you wish to turn off
this waterfall, remove the cover and rotate the handle upward; then replace the cover. Adjusting one or more jets to its minimum flow increases
the flow of the waterfall.
CAUTION: The water recirculating through the second Water Rainbow spout is not fresh water and therefore is not suitable for drinking.
TYPICAL BATH FITTINGS
MAGIC TOUCH WHIRLPOOL
FULLY ADJUSTABLE JETS
SUCTION
COVER
WATER RAINBOW
FILL SPOUT (OPTIONAL)
FILL TO AT LEAST
2" ABOVE HIGHEST JET
ON/OFF SWITCH
AIR CONTROL
KNOBS
DRAIN/OVERFLOW
(OPTIONAL)
*
FIORE
HOT AND COLD FAUCET HANDLES
MAIN
DIVERTER
HANDLE
WATER
RAINBOW
FLOW
CONTROL
HANDLE
WATER
RAINBOW
FILL SPOUT
SECOND WATER RAINBOW (RECIRCULATING)
FLOW CONTROL HANDLE
14
VANITY COVER
MIRROR
HAND-HELD
SHOWER
VANITY AREA
WATER RAINBOW SPOUT