Specifications; Rectangular Baths - Jacuzzi Luxury Serie Mode D'emploi

reCtaNguLar Baths

iMPOrtaNt: Read complete instructions before beginning
installation.
Each whirlpool bath arrives ready for installation, completely
equipped with motor/pump assembly, heater, plumbing, and
fittings necessary for whirlpool operation. An optional drain/
overflow kit is available for installation on the bath.
Remove the bath from the carton. Retain the shipping carton
until satisfactory inspection of the product has been made.
CautiON: Do not lift the bath by the plumbing at any time;
handle by the shell only.
Immediately upon receipt, inspect the shell before installing.
Should inspection reveal any damage or defect in the finish,
L
Heater
2"
4"
(51 mm)
(102 mm)
SIDE VIEW
allusion
L
Heater
2"
(51 mm)
SIDE VIEW
Bellavista
1/2" Max
L
Heater
Motor
SIDE VIEW
elara
1/2" Max
L
H
Heater
SIDE VIEW
sabella
Jacuzzi Luxury Bath Series: Installation and Operation
©

sPeCiFiCatiONs

1" Max
W
H
Motor
END VIEW
1/2" Max
W
H
Motor
END VIEW
W
H
1/2"
(13 mm)
END VIEW
2"
(51 mm)
W
(25 mm)
Motor
END VIEW
do not install the bath. Damage or defect to the finish claimed
after the bath is installed is excluded from the warranty.
Jacuzzi Whirlpool Bath's responsibility for shipping damage
©
ceases upon delivery of the products in good order to the
carrier. Refer any claims for damage to the carrier. For
definitions of warranty coverage and limitations, refer to the
published warranty information packed with the product.
All bath units are factory tested for proper operation and
watertight connections prior to shipping.
NOte: Prior to installation, the bath must be filled with water
and operated to check for leaks that may have resulted
from shipping damage or mishandling. Jacuzzi
Bath is not responsible for any defect that could have been
discovered, repaired, or avoided by following this inspection
and testing procedure.
L
2"
(51 mm)
Heater
SIDE VIEW
L
Heater
SIDE VIEW
H1
2"
1"
(51 mm)
SIDE VIEW
Page 
Whirlpool
©
A
B
Drain/Overflow
1/2" Max
W
H
Motor
END VIEW
Ciprea™, rh
1/2" Max
W
H
Motor
END VIEW
reál, rh
1/2" Max
L
Heater
H2 H3
Motor
END VIEW
torretta 36
K339000Y • April 2008
2"
(51 mm)
W