Operation; Air Bath Controls; Pro 3 Ozone Sanitation System - Jacuzzi PURE AIR II Amiga Instructions D'installation Et De Fonctionnement

AIr BAth CoNtroLS

Air Bath Control operation
Normal mode
Press the Normal Mode button to turn the blower on.
The blower will be on for 20 minutes. The intensity
may be changed by using the Toggle Switches.
Pressing the Normal Mode button a second time will
turn the blower off.
Wave mode
Press the Wave Mode button to change the blower's
power from a minimum to a User-defined maximum.
Press the Wave Mode button a second time to
return to Normal Mode where the blower's power is
constant.
toggle Switches
In the Normal mode, use the Toggle Switch (Up or
Down) to increase or decrease the intensity of the air
blower. In the Wave mode the switches change the
blower to a user-defined intensity.
The Toggle Switch affects the motor speed a step
at a time. Do not hold the button down but press the
button repeatedly to lower or raise the speed.
NotE: The balanced air flow feature has been
optimized for use at the highest blower operation
setting. As you decrease the speed of the blower
to the lowest setting, it is normal to experience a
gradual loss of pressure and air bubbles, especially
toward the drain-end of the bath.
Jacuzzi ® Comfort Pure Air II Bath: Installation and Operation
™

oPErAtIoN

3
Pro ozoNE SANItAtIoN SYStEm
The unit has a PrO
ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for 30
minutes, and then it will automatically shut off. Thereafter,
every 4 hours, the ozone will operate for about 20 minutes.
NotE: A soft noise is produced by the pump during operation
of the equipment.
Page 16
3 Ozone Sanitation System installed. The
BM62000D • February 2008