Service Access - Jacuzzi Luxury Serie Mode D'emploi

serViCe aCCess

(Corner and Regular Baths)
For partially or fully sunken installations, allow for access
to service connections. It is the installer's responsibility
to provide sufficient service access. The recommended
minimum dimensions allowable for service to the bath are
shown in the "Service Access" illustration.
Provide adequate area around the unit for air circulation for
cooling the motor and to supply sufficient air to the jets. Do
not insulate this area or around motor.
serViCe aCCess (regular Baths)
FRONT
12"
Alternate
Access
18"
serViCe aCCess (Corner Baths)
18"
C
36"
Jacuzzi Luxury Bath Series: Installation and Operation
©
12"
Motor
Preferred
18"
Access
20"
A
B
24"
Page 1
The Duetta Whirlpool baths should access as shown below.
Duetta serViCe aCCess (Without skirt)
FRONT
12"
Preferred
Access
18"
The Allusion Whirlpool baths should access as shown below.
aLLusiON serViCe aCCess
FRONT
12"
Alternate
Access
18"
In some cases, access may not have been provided because
of the design of the bath environment and having full
understanding that in this case, it may be necessary to remove
the unit for service.
If this is the case, diagnosing a problem may not be possible
without complete access to the plumbing system. This would
necessitate the removal of the unit. Although this practice is
not commonly implemented, it is an acceptable method.
NOte: In some cases, access for Preferred Access may have
been provided. If service is required in the Alternate Access,
the unit will be pulled for service and reinstalled.
If service access has not been provided, it is the homeowner's
responsibility to remove the bath and provide the required
access, should a repair become necessary.
.
Heater 12"
Motor
Alternate
Access
18"
12"
Heater
Motor
Preferred
Access 18"
K339000Y • April 2008