Begin Installation - Jacuzzi Luxury Serie Mode D'emploi

Begin installation

1. Optionally, use a washable marker to scribe a reference
line 1" (25.4 mm) outside the cutout edge on the deck
surface. This may assist in final alignment of the tub.
CautiON: Install any trim kits, faucets, or other tub
components before installing.
2. To install unit insert the motor/pump end first when
lowering the tub into the cutout opening as shown in
the bottom illustration. Do not use plumbing fixtures or
plumbing lines to lower unit. The clearance under the
substrate is required for air flow circulation requirements.
3. Place a piece of scrap lumber under each corner
as a temporary support for the tub rim. Inspect all
fittings, plumbing, and control lines after inserting to
insure components are not damaged, disconnected,
or contacting the finish surface substrate or support
members.
4. Connect flex water supply lines to faucet.
5. Plug power cords into GFCI outlet.
6. Remove fingers, hands, and all other items from under
the rim edge before lowering the tub. Slightly lift one
tub end and remove the scrap lumber. Gently lower the
tub rim until it contacts the deck surface. Slightly lift the
remaining tub end and remove the scrap lumber. Gently
lower the tub rim until it contacts the deck surface.
If you created the optional reference lines, align the tub
over the cutout.
7. Connect drain line.
8. Turn ON the power supply to the dedicated GFCI
protected circuits.
9. Check for leaks and check system operation.
Tile or finished
surface
Substrate
Jacuzzi Luxury Bath Series: Installation and Operation
©
Minimum clearance (Duetta 3 to 3-1/2")
Support
member
Tub cutout" Tub cutout"
Reference line Reference line
2-1/2"
Approx.
2" Thickness,
Subfloor
Support
Subfloor
member
Page 1
1/2"
Finished surface
Scrap lumber
max
Substrate
Support
Tile or finished
surface
Substrate
TYP: 1-1/2"
Clearance, min.
K339000Y • April 2008