Lighting (Optional Illumatherapy™ Lighting) - Jacuzzi Luxury Serie Mode D'emploi

suCtiON/iNtaKe COVer/straiNer
Clean the suction/intake cover/strainer of hair and debris when
necessary. To do this, remove the center screw and detach
the square cover. Clean the cover by backflushing debris from
the holes. Replace the suction/intake cover immediately after
cleaning. When reinstalling, orient the cover/strainer with the
small notch at the bottom. The gasket must be inserted into
the groove of the cover/strainer before reinstalling onto the
suction fitting.
CautiON: Keep hair a minimum of 6 inches (152 mm) away
from the suction/intake fitting at all times when the whirlpool
system is operating. Hair longer than shoulder length should
be secured close to the head, or a bathing cap should be
worn. Do not operate the whirlpool system with the suction/
intake cover removed! It is a safety device and must always
be in place on the suction fitting to minimize the potential
hazard of hair or body entrapment.
LightiNg (Chromotherapy)
Your unit has Chromotherapy (LED) lighting. If the lights
fail to function contact your Jacuzzi
There are no customer serviceable components on the
Chromotherapy lighting.
Replacement fixtures are available from your Jacuzzi
Whirlpool Bath dealer.
LightiNg (Optional illumatherapy™)
If your unit has Illumatherapy (fiberoptic) lighting and the lights
fail to function contact your Jacuzzi
There are no customer serviceable components on the
Illumatherapy lighting.
Replacement fixtures are available from your Jacuzzi
Whirlpool Bath dealer.
Jacuzzi Luxury Bath Series: Installation and Operation
©
Whirlpool Bath dealer.
©
©
Whirlpool Bath dealer.
©
©
Gasket
Cover strainer
Screw
Notch
suction Cover, strainer assembly
Page 2
Suction
fitting
K339000Y • April 2008