Temperature Limitation; Reset To Factory Setting; How To Save Energy; Power Limit - clage DSX Mode D'emploi Pour L'utilisateur

2. How to use
Temperature limit on
1 2
+
Press
≥ 3 sec
Display
confirms
activation:
3
Temperature limit off
+
1
Press
≥ 3 sec
Display
confirms
deactivation:
2
Reset
1 2
Press + hold!
3
Reset completed

Temperature limitation

This instantaneous water heater is equipped with an optional temperature limiting
function. This scalding protection is deactivated in the works setting.
Switch on:
Select the limit tem per ature with arrow keys
arrow key simultaneously for at least 3 sec. The display briefly confirms the activa-
tion by "
TEMP PROTECTION ENABLED
After activation of the scalding pro tec tion it is impossible to select a higher tempera-
ture.
Switch off:
Press info key and arrow key
con firms the deacti vation by "

Reset to factory setting

All factory settings can be recalled:
• Press setup key , the display now counts backwards from "10" to "00" in second
intervals. The appliance is reset at value "00" – if you stop pressing the key earlier,
the process will be cancelled.

How to save energy

Set the exact temperature you need on the appliance and open the hot water tap.
Once you feel that the water is too hot, do not add any cold water and, instead, enter
a lower temperature on the appliance. If you were to add cold water, the water already
heated would cool down again and valuable energy would be wasted. Moreover, the
cold water added in the tap is not covered by the control range of the electronic cir-
cuitry, with the result that temperature constancy is no longer guaranteed.

Power limit

If the full output of the instantaneous water heater DSX does not suffice to heat the
tapped quantity of water, the control valve automatically reduces the flow rate so that
the set temperature is reached.

Top-up heating

When operating with preheated water (e.g. with solar systems), you must ensure that
the inlet temperature does not exceed 70 °C.
If the inlet temperature exceeds the setpoint, the appliance is not providing any out-
put, and the display shows
" INLET TEMP TOO HIGH ".
19
and , then press info key
".
simultaneously for at least 3 sec. The display briefly
".
TEMP PROTECTION OFF
CLAGE
EN
and