How To Use; Temperature Setting; Programme Buttons; Temperature Limitation - clage DEX Mode D'emploi

2. How to use

Set temperature
1
–1 °C
Select preset temperature
A1 A2
B1 B2
Store temperature
1 2
Set required
temperature
(e.g. 43 °C)
Press
≥ 3 sec
4 3
Display of new value (e.g. 43 °C)
Temperature limit on
1 2
+
Press
≥ 3 sec
Temperature limit off
2
1
+
Press
Confirmation
≥ 3 sec
of deactivation
As soon as you open the hot water tap, the instantaneous water heater switches
on auto matically. When the tap is closed, the appliance automatically switches
off.

Temperature setting

• You can set the required temperature gradually to a lower or higher value with the
arrow keys
+1 °C
time. Pressing a key for a longer time changes the temperature continuously. You
can select the outlet temperature in a range from 20 °C to 60 °C.
Note: If temperature is set below 20 °C with arrow key
and the appliance switches off the heating function.
Note: If the water heater supplies a shower, the maximum temperature was
reduced during initial operation. This limitation cannot be exceeded.

Programme buttons

The two programme buttons
When pressing a programme key, the preset temperature is selected and displayed.
The factory setting for programme
assign your own settings for the programme keys:
• Prolonged pressing of the programme key stores the previously selected tem­
perature. The display changes from "P1" or "P2" to the newly stored temperature
value. This newly set temperature is now available to you each time you press the
corresponding program key.

Temperature limitation

The instantaneous water heater DEX is equipped with an optional temperature limit­
ing function. This scalding protection is deactivated in the factory setting.
• Switch on: Select the limit tempe ra ture, then press
least 3 sec. The dis play briefly confirms the activation by "HI".
• Switch off: press program key
play briefly confirms the deactivation by "--".
Note: By activation of the temperature limit also the programme keys are limited.
Therefore, the fixed values of the programme keys may be set again after deacti­
vation of the temperature limitation.
and . The temperature changes by 1 °C if key is pressed shortly one
and allow to quickly select the preset temperature.
is 35 °C and for programme
and simultaneously for at least 3 sec. The dis­
7
CLAGE
the display shows "--"
it is 48 °C. You can
and simul taneously for at
EN