How To Use; Temperature Setting; Programme Keys - clage DSX Mode D'emploi Pour L'utilisateur

DSX ELECTRONIC MPS®

2. How to use

EN
Set temperature
1
–1 °C
35,0..42,0 °C Convenience zone
1
–0,5 °C
Select preset temperature
A1
B1
C1
D1
Store temperature
2
1
3
As soon as you open the hot water tap, the instantaneous water heater switches
on auto ma ti cally. When the tap is closed, the appliance automatically switches
off. The water heater is operated at the device itself or with the wireless remote
control.

Temperature setting

You can set the required temperature gradually to a lower or higher value with the
arrow keys
+1 °C
between 35 °C and 42 °C even by 0.5 °C, if key is pressed shortly one time. Pressing a
key for a longer time changes the temperature continuously. You can select the outlet
temperature from 20 °C to 60 °C. The display confirms the temperature changes by
"warmer" respectively "colder".
+0,5 °C
Note: If temperature is set below 20 °C with arrow key
and the appliance switches off the heating function.
Note: If the water heater supplies a shower, the maximum temperature was
reduced during initial operation. This limitation cannot be exceeded.
A2

Programme keys

B2
The four programme keys at the device allow to quickly select the preset temperature.
The factory setting for application "hand wash"
it is 38 °C, for application "bath tub"
C2
48 °C.
You can assign your own settings for the programme keys:
D2
Select the desired temperature via the arrow keys
least 3 seconds) of one of the four programme keys stores the previously selected tem-
perature. The display confirms by "
The stored temperature is now avai lable to you each time you press the corresponding
programme key.
Press ≥ 3 sec
and . The temperature changes by 1 °C, in the convenience zone
it is 42 °C, and for application "kitchen"
" and an acoustic signal will resound.
--OK--
14
the display shows "--"
is 35 °C, for application "shower"
and . Prolonged pressing (at
it is