Commissioning; Starting With The Power Supply; Starting With Remote Volt-Free Contact; Starting With Local Run/Stop Control (Bma 31/32, Bma 33/34 Or Bmavar 31/32, Bmavar 33/34 Option) - Leroy Somer VARMECA 30 Installation Et Maintenance

LEROY-SOMER

4 - COMMISSIONING

• Before switching on the VARMECA 30, check that
the electrical connections are correct, and that any
moving parts are mechanically protected.
• For the safety of personnel, the VARMECA 30 must not be
switched on with the protective cover removed.

4.1 - Starting with the power supply

since the run command has been factory-enabled via a jumper,
the motor starts as soon as it is switched on.
the speed is adjusted with the local control knob (B 31/32 or
B 33/34 option) or a remote reference (0-10 V or 4-20 ma).
Power-up: the green indicator lamp is lit continuously.
the control terminals sDI1 and sDI2 (Vma 33/34) or 11 and 12
(Vma 31/32) are linked (unlocking).
4.1.1 - Automatic starting
By leaving the wire between control terminals 8 and 11
(Vma 31/32) or DI2 and +24V (Vma 33/34), the motor
starts running forward.
4.2 - Starting with remote volt-free
contact
once it has been switched on, the motor starts in accordance
with the run command given by the closing of the volt-free
contact corresponding to the desired direction of rotation.
the speed is adjusted with the local control knob (B 31/32 or
B 33/34 option) or a remote reference (0-10 V or 4-20 ma).
InstallatIon anD maIntenance
VARMECA 30
Variable speed motor or geared motor
4.3 - Starting with local run/stop control
(BMA 31/32, BMA 33/34 or BMAVAR
31/32, BMAVAR 33/34 option
once it has been switched on, the motor starts after the control
knob corresponding to the desired direction of rotation has
been pressed for one second.
the speed is only adjusted with the local control knob.

4.4 - Setting the speed

4.4.1 - External reference
adjust the speed reference using the chosen reference
(0/10 V or 4/20 ma).
4.4.2 - Control knob options (B 31/32 or B 33/34)
and remote potentiometer option
adjust the speed reference using the control knob or the 10 kW
remote potentiometer.
4.4.3 - Internal speed control option (CVI VMA
31/32 or CVI VMA 33/34)
adjust the speed reference using the Int. spd. potentiometer.
adjust the max. spd. or min. spd. potentiometers if it is not
possible to reach the desired speed.
3776 en - 2013.06 / k
25