MTD J14 Notice D'instructions page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Operating instructions
Fault
Engine does not start.
Engine runs irregularly
(stutters).
Unit does not sweep.
Unit does not move.
Bad sweeping result.
Excessive vibration.
Gears can be changed
only with difficulty.
1
) See "engine instructions".
2
) This work can only be executed by a specialist workshop.
Possible cause
Fuel tank empty.
Stale fuel.
Engine in a cold state, choke not set
to "
/ON/CHOKE".
Throttle not set to "
Spark plug terminal not attached.
Spark plug contaminated or defective.
Primer not actuated.
Choke lever set to "
Spark plug terminal loosely attached.
Stale fuel. Water or dirt in the fuel system. Drain off stale fuel into a suitable vessel
Fuel tank cap vent blocked.
Sweeping brushes very dirty.
Clutch cable for sweeping brush drive
not set correctly.
V-belt loose or torn.
Clutch cable for travel drive not set
correctly.
V-belt loose or torn.
Brush pressure too high.
Sweeping brushes worn.
Collecting tank (accessories)
not attached correctly.
Loose parts, damaged sweeping brushes
or damaged drive parts.
Clutch cable for travel drive not set
correctly.
Remedy
Refill the fuel tank.
Drain off stale fuel into a suitable vessel
in the open air
Refill tank with clean, fresh fuel.
Set choke set to "
/FAST".
Set throttle to "
Attach spark plug terminal to spark plug.
Clean spark plug
plug replaced
Press primer.
/ON/CHOKE".
Set choke to "RUN/OFF/
Firmly attach spark plug terminal.
in the open air
fresh fuel.
Clean tank cap and vent hole.
Switch off engine, remove spark-plug
terminal. Clean sweeping brushes.
Set clutch cable (see "Setting clutch
for sweeping brush drive").
Have loose V-belts tensioned
Have torn V-belts replaced
Set clutch cable (see "Setting clutch
for travel drive").
Have loose V-belts tensioned
Have torn V-belts replaced
Adjust support wheels to reduce
the brush pressure.
Replace brush rollers in pairs.
Attach collecting tank correctly.
Stop engine immediately and remove
spark plug terminal.
Tighten loose screws and nuts.
Have damaged parts repaired
Set clutch cable (see "Setting clutch
for travel drive").
1
).
/ON/CHOKE".
/FAST".
1
). Have defective spark
2
).
".
1
). Refill tank with clean,
2
).
2
).
2
).
2
).
2
).
English
13

Publicité

Table des Matières
loading

Produits Connexes pour MTD J14

Ce manuel est également adapté pour:

769-10016a

Table des Matières