Mercedes-Benz LINGUATRONIC Notice D'utilisation Complémentaire page 21

To select the navigation application:
X
press the ? button on the multifunction
steering wheel.
Say the command "Navigation".
X
Press the ? button on the multifunction
X
steering wheel.
Say one of the navigation commands
X
explained below.
Commands
You cannot start route guidance until all the
necessary address data has been entered.
The commands for entering an address can
be found from ( page 20).
Y
"Help navigation"
Use the command "Help navigation" to have
the main commands for the navigation
system read out.
The main categories are read out first. After
a main category has been selected, the
available commands are read out.
"Route information"
You can use the command "Route
information" to have the following
information on your currently planned route
read out:
distance to destination
R
approximate time of arrival
R
remaining travel time
R
"Guidance instructions"
When you use the command "Guidance
instructions on", the Voice Control System
repeats the last driving instruction. If the
driving instruction output has been switched
off up to this point, it is now switched on
again.
"Guidance instructions off" or
"Guidance instructions on"
You can use these commands to switch voice
output for route guidance on/off.
"Map"
You can use this command to switch on the
map or to switch to the map view.
"Zoom in" or "Zoom out"
You can use these commands to increase or
decrease the scale of the map on the display.
"Zoom in completely" or "Zoom out
completely"
You can use these commands to set the map
display directly to the smallest or largest
scale.
"Map orientation"
You can change the map orientation with the
following commands:
"Map north up"
R
"Map heading up"
R
"Map bird's-eye view"
R
"Map 3D view"
R
Displaying symbols for POIs
You can display POI symbols on the map.
Two categories are available:
standard POI symbols
R
personal POI symbols
R
You can select personal POI symbols in
advance via COMAND using
SettingsQMap ContentsQPOI
Symbols on Map.
The following commands are possible:
"Standard POI symbols"
R
"Personal POI symbols"
R
"No symbols"
R
Navigation
19
Z