Maintenance And Care; Contact Information - APA 16442 Manuel De L'opérateur

6.3 JUMP-START FOR 12 V VEHICLES
1. Switch off the ignition and all consumers on your vehicle.
2. Make sure that at least three control lamps (at least 75 % battery capacity) of
the charging status display light up continuously and that the battery poles of
your vehicle battery are not dirty or oxidized. Connect the power pack and the
jumper cable (Position 9 in the overview) by plugging in the jumper cable of the
start box into the jumper cable (position 3 in the overview) of the power pack,
see figure 2. Make sure that the plug is firmly and securely inserted. The control
lamp of the start box flashes alternately red/green.
3. First connect the red pole clamp of the jumper cable to the positive pole and then
the black pole clamp to the negative pole of the vehicle battery. The pole clamps
must have a firm and secure contact to the battery poles.
If the polarity of the cables is reversed or in case of a short circuit, the control lamp
of the start box lights up red and a warning tone sounds.
4. If the jumper cables are connected correctly, switch on the ignition of your
vehicle. The control lamp is now permanently green.
5. Now start the vehicle's engine. Do not operate the starter for longer than 3 se-
conds. If the start attempt is not successful, wait for at least two minutes before
starting the next attempt. After the third failed attempt, do not attempt again.
Instead, check your vehicle for faults.
6. Disconnect the jump-starter from the power pack. Then remove the pole
clamps from the vehicle battery.
6.4 USE OF THE LED LIGHT / SIGNAL LIGHT
To switch on the continuous light of the LED light, hold down the ON switch (Position 6 in the overview) of the power pack for approx. 3
seconds. You can then switch on the following lighting functions one after the other by pressing the switch again: Flashing– SOS – OFF.
6.5 CHARGING USB DEVICES
Select the appropriate connector on the USB 4- in-1 cable (Position 8 in the overview) for your USB device and connect it. Connect
your USB connector to the USB port (Position 2 in the overview) of the power pack. Press the switch (Position 2 in the overview) on
the power pack to start charging.
After the charging process has been completed, the control lamps for the charging status (Position 7 in the overview) switch off. First
disconnect the charging cable from the power pack, then remove the charging cable from your USB device.

7. MAINTENANCE AND CARE

7.1 CLEANING
Only clean the mini lithium power pack with a soft cloth and do not use any aggressive cleaning agents or solvents. Never allow
liquids to ingress into the housing.
7.2 STORAGE
When not in use, store the mini lithium power pack in a dry place. Do not expose the power pack to moisture, oil, dust, dirt, high
temperatures, strong vibrations, or mechanical load. Always store the power pack with the jump-start lead disconnected to prevent
short circuits between the pole clamps.
7.3 MAINTENANCE
Charge the power pack every three months when not in use.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be collected separately
and disposed of in an environmentally responsible manner for recycling. Please contact your community or city adminis-
tration regarding disposal options for electrical and electronic scrap.
The materials are recyclable. You make an important contribution to protecting our environment by recycling, material
utilisation or other forms of reusing waste equipment!

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
8
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 2: Connecting the jumper cable
Figure 3: Control lamp start box
info@eal-vertrieb.com
www.eal-vertrieb.com