Charging 19 V Notebooks; Using The 12 V Outlet; Using The Led Lights / Signal Lights; Maintenance And Care - APA 16477 Mode D'emploi

6.5 Charging 19 V Notebooks

To operate or charge a 19 V Notebook, select the right adaptor for your Notebook from the adaptor set (Position 16
in the overview). Connect this adaptor with the adaptor cable (Position 15 in the Overview). Plug the adaptor into
the charging outlet of your Notebook. Connect the other end of the adaptor cable with the 19 V outlet (Position
9 in the overview) of the power pack. Start charging by pushing the switch of the power pack (Position 2 in the
overview). After charging has finished, the LEDs for the charging status (Position 3 in the overview) will go out. Pull
the adaptor cable out of the power pack first, and then remove it from your Notebook.

6.6 Using the 12 V outlet

Warning: The 12 V connection socket has the same design as the 19 V. Make sure you do not get them
mixed up.
To operate other 12 V devices (cooling boxes, mobile TVs etc.), first select the right adaptor for your device from
the adaptor set (Position 16 in the overview). Connect this adaptor with the adaptor cable (Position 15 in the
Overview). Plug the adaptor into the connection socket of your 12 V device. Connect the other end of the adaptor
cable with the 12 V outlet (Position 10 in the overview) of the power pack. Pull the adaptor cable out of the power
pack after use. The LEDs for the charging status (Position 3 in the overview) will then automatically go out. Remove
the adaptor cable from your 12 V device.

6.7 Using the LED lights / signal lights

To turn the continuous LED light on, keep the switch (Position 1 in the overview) of the power pack pressed down
for approx. 3 seconds. You can then switch on the following light functions one after the other, by repeatedly
pressing the switch: flashing, SOS, off.

7. Maintenance and care

7.1 Cleaning

Only clean the lithium power pack with a soft cloth and do not use any aggressive cleaning agents or solvents. Never
allow liquids to ingress into the housing.

7.2 Storage

When not in use, store the lithium power pack in a dry place. Do not expose the power pack to moisture, oil, dust,
dirt, high temperatures, strong vibrations, or mechanical load. Always store the power pack with the jump lead
unplugged, to prevent bypasses between the cable clamps.

7.3 Maintenance

Charge the power pack every three months when not in use.

8. Notes regarding environmental protection

Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be
collected separately and disposed of in an environmentally responsible manner for recycling. Please
contact your community or city administration regarding disposal options for electrical and electronic
scrap.
The materials are recyclable. You make an important contribution to protecting our environment by
recycling, material utilisation or other forms of reusing waste equipment!

9. Contact information

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
11