Charging Usb Devices; Using The 12V Output; Using The Led Lights / Signal Lights; Error Search/Troubleshooting - APA E-Power 78F Manuel De L'opérateur

6.5 USING THE 12V OUTPUT

Connect your 12V device to the 12V power output (position 13 in the overview) with a 12V vehicle plug. Push the ON switch (position
5 in the overview) to start charging. After use, switch off your 12V device and remove the plug from the 12V output of the power pack.
The power pack will switch off after approx. 30 seconds.

6.6 USING THE LED LIGHTS / SIGNAL LIGHTS

To switch on the continuous light of the LED bulb (position 14 in the overview), hold down the ON switch (position 5 in the overview) of
the power pack for approx. 3 seconds. You can then switch on the following light functions one after the other, by repeatedly pressing
the switch: Flashing, SOS, off.

6.7 ERROR SEARCH/TROUBLESHOOTING

Problem
Acoustic warning signal
Display screen:
OUTPUT LOCKED
No jump-start possible
Flashing display message:
OUTPUT LOCKED
No display message

7. MAINTENANCE AND CARE

7.1 CLEANING

Only clean the lithium power pack with a soft cloth and do not use any aggressive cleaning agents or solvents. Never allow liquids to
get into the housing.

7.2 STORAGE

When not in use, store the lithium power pack in a dry place. Do not expose the power pack to moisture, oil, dust, dirt, high temperatures,
strong vibrations, or mechanical load. Always store the power pack with the jump lead unplugged, to prevent short circuits between
the cable callipers.
7.3 MAINTENANCE
Charge the power pack every three months when not in use.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with household waste. Electrical devices and electronic scrap must be collected
separately and disposed of in an environmentally responsible manner for recycling. Please contact your community or
city administration regarding disposal options for electrical and electronic scrap.
The materials are recyclable. You make an important contribution to protecting our environment by recycling, material
utilisation or other forms of reusing waste equipment.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
Cause
Connected pole callipers switched
short circuit
1. Pole calliper or cable is defective
2. Internal battery is weak
3. Internal components are defective
More than three jump-start attempts
were made with too short a break
1. The USB or 12V output is overloaded
and the short-circuit protection has
tripped.
2. Weak battery
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Remedy
Connect pole callipers correctly,
remove contact between the pole callipers
1. Repair or replace pole calliper or cable
2. Fully charge power pack
3. Contact the dealer. Repairs may only be carried out by a
specialist workshop.
The internal battery of the power pack is overheated. Let
the power pack cool down. Only then can you start a new
jump-start attempt.
1. Push the ON switch
2. Fully charge power pack
info@eal-vertrieb.com
www.eal-vertrieb.com
11