Charging Usb Devices; Using The Led Torch / Signal Lamp; Replacing The Fuse In The Vehicle Charging Cable; Cleaning, Storage And Maintenance - APA 16480 Manuel De L'opérateur

6.4 CHARGING USB DEVICES

Select the appropriate adapter (Position15 in the overview) for your USB device and connect it. Plug the USB plug
(Position 14 in the overview) to the USB output (Position 3 in the overview) of the power pack. Press the push
button (Position 1 in the overview) of the power pack to start the charging process.
After the charging process is finished the LED's for the charge status (Position 2 in the overview) go out. First pull the
charging cable out of the power pack and then remove the charging cable from your USB device.

6.5 USING THE LED TORCH / SIGNAL LAMP

To switch on the LED torch keep the ON/OFF switch (Position 1 in the overview) of the power pack pressed for ap-
prox. 3 seconds. Press the switch again to switch on the following light functions consecutively: Flashing, SOS, off.

6.6 REPLACING THE FUSE IN THE VEHICLE CHARGING CABLE

Turn the knurled nut at the tip of the 12 V plug (Position 9 in the overview) counter clockwise until the plug comes
off and remove it. The fuse is released and can be pulled out of the plug. Replace it with a new fuse of the same
amperage and screw the knurled nut back into the plug.

7. CLEANING, STORAGE AND MAINTENANCE

7.1 CLEANING

Clean the Mini Lithium Power Pack only with a soft cloth and do not use any aggressive cleaning agents or solvents.
Never allow liquids to ingress into the housing.

7.2 STORAGE

When not in use, store the Mini Lithium Power Pack in a dry place. Do not expose the power pack to moisture, oil,
dust, dirt, high temperatures, strong vibrations, or mechanical stress. Always store the power pack with the jumper
cable pulled off to prevent a short-circuit between the battery terminal clamps.

7.3 MAINTENANCE

Charge the power pack every three months when not in use.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

The packaging is made up of environmentally friendly materials which may be disposed of via your
local recycling points. Do not put electrical devices into the household waste. Electronic and electrical
devices must be collected separately and sent for environmentally friendly recycling. Contact your
community or town administration for information regarding the disposal of electrics.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
12
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com