Attempting To Start; Removing The Power Pack; Use As 12 V Voltage Supply; Working Light - APA 16524 Manuel De L'opérateur

red (+) pole callipers (Position 1 in the overview) to the plus pole of your vehicle battery. The black (-) pole callipers (Position
10 in the overview) is connected, as far as possible from the battery, to the motor block or chassis (not to a painted part). If the
power pack has been connected correctly, the incorrect poling protection display (Position 8 in the overview) lights in green. If
this is not the case, the incorrect poling protection display lights in red and an acoustic warning is issued. In this case, check the
connections of the pole callipers and correct. Now rotate the On/Off switch for the starter aid to the ON position.

6.8 ATTEMPTING TO START

Start the motor. Do not operate the starter for longer than 6 seconds. The battery of the power pack is not designed for longer
starting attempts. Pause for at least 5 minutes between two starting attempts. If the motor does not start after a number of
attempts, abort the process and investigate the cause of the defect.

6.9 REMOVING THE POWER PACK

Rotate the On/Off switch for the starter aid and the selection switch for starter aid voltage to the OFF setting. First disconnect
the black (-) pole calliper, coil the cable and attach the pole calliper to the designated holder. Then disconnect the red (+) pole
calliper, coil the cable and attach the pole calliper to the designated holder. Always maintain this sequence. Recharge the power
pack.

6.10 USE AS 12 V VOLTAGE SUPPLY

The power pack can be used as a 12 V direct current source for many devices that can be operated with 12 V direct current and a
cigarette lighter plug. Plug the cigarette lighter plug of the device you wish to operate into the 12 V outlet. The device you wish
to operate should not require a current greater than 10 A. The outlet of the power pack has an automatic fuse that will deactivate
the device at a current greater than 10 A. If deactivation occurs, immediately disconnect the power pack and the operating
device. After approximately three minutes, the fuse will free the outlets for use.

6.11 WORKING LIGHT

The ON-OFF switch (Position 19 in the overview) is used to switch the LED working light as well as the illumination of the pole
callipers on and off.

7. MAINTENANCE AND CARE

Wartung: Store the power pack at room temperature. If the power pack is not used for a longer period of time, it must be
recharged. In winter, recharge every two months, in summer recharge every month.
S
Pflege:
witch the power pack off before cleaning. Clean the housing of the power pack with a soft, dry cloth. Do not use any
aggressive cleaning agents or solvent-based cleaners. Never allow liquids to ingress into the housing.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be collected se-
parately and disposed of in an environmentally responsible manner for recycling. Please contact your community
or city administration regarding disposal options for electrical and electronic scrap.
You are legally obliged to return batteries and battery packs. After use, they may be returned to us, handed in to
a communal collection point, or to a local dealer. Batteries containing hazardous materials are labelled with a
symbol consisting of a crossed out trash can and the chemical symbol (Cd, Hg or Pb) which designates the heavy
Pb
metal responsible for the hazard.

9.CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Deutschland
10
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com