Charging The Power Pack With The Plug Charger; Checking The Charging Status - APA 16442 Manuel De L'opérateur

• Do not attempt to remove and replace the battery pack of the power pack. If the battery comes to the end of its useful life,
dispose of the entire in accordance with your local guidelines.
• Never charge the power pack using a damaged charger.
• Do not leave a power pack unattended during operation.
• Only used the supplied accessories to charge the power pack.
• Never attempt to jump-start a vehicle when the battery is frozen, this brings a risk of explosion.
• Store these instructions carefully and, if necessary, pass them on to other users.
5. EXPLANATION OF SYMBOLS
complies with
EC directives
Protective insulation
(safety class II)
6. MANUAL
6.1 OVERVIEW
1 LED lamp
2 USB output 7 Charging status display
3 Cover for EC5 jump-start connector
4 Charging socket
5 USB input
6 ON switch
7 Charge status display
8 USB 4-in-1 cable
9 Jumper cable with start box
10 Charger socket
6.2 CHARGING THE POWER PACK
If it should happen that you have to charge the power pack without being able to supervise it, place it on
a fireproof base (stone, tiles or metal plate) during the charging process. Remove all flammable objects
within one metre of the charger.

6.2.1 CHARGING THE POWER PACK WITH THE PLUG CHARGER

Plug (Position 10 in the overview) into the charging socket (Position 4 in the overview) of the battery pack. Then plug the charger into
a 230 V mains socket.
During the charging process, the control lamps of the charging status display (Position 7 in the overview) flash one after the other,
the number of continuously lit control lamps indicates the charging status of the power pack. When charging is complete, all four
indicator lights are lit continuously.
6.2.2 CHARGING THE POWER PACK WITH THE USB 4-IN-1 CHARGING CABLE
Plug the Micro-B USB connector (Position 8 in the overview) of the USB 4-in-1 charging cable into the USB socket (Position 5 in the
overview) of the power pack. Then plug the USB plug of the cable into a USB charger, the USB output in your vehicle or the USB output
of your computer. Plug the charger into an electrical outlet, switch on the ignition of your vehicle or switch on your computer.
During the charging process, the control lamps of the charging status display (Position 7 in the overview) flash one after the other,
the number of continuously lit control lamps indicates the charging status of the power pack. When charging is complete, all four
indicator lights are lit continuously.

6.2.3 CHECKING THE CHARGING STATUS

Remove the charging cable from the charging socket. Press the device's switch (Position 6 in the overview) to check the charging
status. The charging status can be read from the illuminated control lamps.
Control lamps
Charging Status
the labelled electrical pro-
duct must not be thrown
into the household refuse
Read instructions for use
1 1+2
25 % 50 %
Devices with this label may only
be operated inside (dry environ-
ment)
Polarity of the charging plug
1+2+3 1+2+3+4
75 % 100 %
7