Operating Instructions; Overview; Charging The Power Packs; Charging With The Plug In Charger - APA 16540 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 Switch for starting aid
2 Switch for working light
3 Control lamp for starting aid / incorrect poles
4 Charging socket
5 Working light
6 Control button for charge status
7 Control lamp for charge status
8 12 V motor vehicle socket
9 Pole callipers, black (-)
10 Manometer
11 ON/OFF switch for compressor
12 Air hose with car valve connection
13 Pole callipers, red (+)
14 Motor vehicle charging cable
15 Plug charger
16 Valve adapters

6.2 CHARGING THE POWER PACKS

The power pack is delivered partially charged. After initial purchase/prior to rst use, make sure that the power pack is fully
charged.

6.2.1 CHARGING WITH THE PLUG IN CHARGER

Turn the on-o switch (position 1 in the overview) to the OFF position. Plug the coaxial power connector of the plug-in
charger (position 13 in the overview) into the charging socket of the power pack (position 4 in the overview). Now plug the
plug-in charger into the socket. The control LED (position 5 in the overview) is now red. For the initial charging process, leave
the power pack connected for 24 hours. For all subsequent charging processes or directly after use charge no longer than 20
hours. Once the battery is fully charged, the LED is green. After the charging process, rst pull out the plug-in charger from
the socket and then unplug the coaxial power connector from the charging socket of the power pack. Now close the charging
socket with the sealing plug. If you press the battery test switch now, the control LED is green.
10
Fig. 1: Overview