Safety Notes; Operating Instructions; Overview; Charging The Power Pack - APA 16524 Manuel De L'opérateur

5. SAFETY NOTES

• This device is not a toy. Keep children away and
do not allow children to operate this device!
• Do not treat packaging material carelessly. This
may become a dangerous plaything for a child!
• Only use this product as intended!
• Do not manipulate or dismantle the device!
• For your own safety, only use accessories and
spare parts that are stated in these instructions
or that are recommended by the manufacturer!
• When using lead batteries, always wear
protective goggles and clothing.
• Lead batteries contain aggressive, corrosive
acids. Prevent skin and eyes from coming into
contact with the lead battery fl uids! Never
dismantle the lead battery! Wash aff ected skin
thoroughly using soap and water. If acid has
entered an eye, rinse immediately for at least
10 minutes under clean, running, lukewarm
water! Then immediately consult a doctor!
• If your clothing has acid on, rinse immediately
with plenty of soap and water!
• Never wear rings, necklaces, watches or
similar when handling batteries or chargers.
The short-circuiting of the battery contacts
brings a risk of burns and explosion!
• The power pack is only designed as a starting
aid for a vehicle that has a battery of its own.
The power pack cannot replace the vehicle
battery.
• Always store the pole callipers in the
designated holders to ensure that the power
pack is not at risk of short-circuiting when not
in use.
• Do not attempt to remove and replace the
battery pack of the power pack. If the battery
comes to the end of its useful life, dispose of
the entire power pack in accordance with your
local guidelines.
• Never charge the power pack using a damaged
charger.
• Only used the supplied accessories to charge
the power pack.
• Never attempt to start a vehicle when the
battery is frozen, this brings a risk of explosion.
• Always observe the following sequence
when disconnecting the power pack from the
battery. There is a risk of explosion: First
disconnect the black (-) pole calliper, coil
the cable and attach the pole calliper to the
designated holder. Then disconnect the red (+)
pole calliper, coil the cable and attach the pole
calliper to the designated holder.

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 Pole callipers, (+) red
2 LED working light
3 Charging control lamp
4 On/Off switch of starter aid
5 Control button for charge status
6 12 V output
7 Voltmeter for charge status
8 Incorrect poling protection display
9 On/Off switch for LED working light
10 Pole callipers, (-) black
11 Charging socket
12 Selection switch for starter aid voltage/charge
13 Plug charger
14 12 V motor vehicle charging cable
Figure 1: Overview, front
Figure 2: Overview, rear

6.2 CHARGING THE POWER PACK

The power pack is delivered in a partially charged state. Charge
the power pack fully after purchase or before using for the fi rst
time.
7