1. In Admin mode, press and hold down both
'2 + 7' buttons
2. Press the KEY ( ) button and the following happens;
•
If your cloudAshur client application registration is enabled, the following happens;
a. All LEDs (RED,
GREEN
b.
GREEN
LED blinks once.
c. All LEDs (RED,
GREEN
d. LEDs return to solid
BLUE
•
If your cloudAshur client application registration is disabled, the following happens;
a. All LEDs (RED,
GREEN
b. All LEDs are off
c. All LEDs (RED,
GREEN
d. LEDs return to solid
BLUE
Note:
When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
24. How to Configure the cloudAshur Encryption Mode
WARNING:
Changing the encryption mode from AES-XTS (default state) to AES-ECB or vice versa will delete
the encryption key and cause the cloudAshur to reset and render all data encrypted by your cloudAshur as
inaccessible and lost forever! Only perform this operation before any data is uploaded to the cloud or local
folders, or you have one or more cloudAshur hardware security modules containing the same encryption key
from which to copy, or if a complete and non-encrypted backup of your data is available.
Perform the following steps to configure the cloudAshur encryption mode to either AES-ECB, indicated by the number '01',
or AES-XTS, indicated by the number '02'. This feature is set as AES-XTS (02) by default. When a specific encryption mode
is configured, the data will be encrypted by the cloudAshur using the corresponding algorithm.
To configure the cloudAshur encryption mode, first enter the "Admin Mode" as described in section 5. Once the cloudAshur
is in Admin Mode (solid
BLUE
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
RED
LED which then fades out to the Idle state (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle state. To unlock and access your data,
LED) proceed with the following steps.
Solid
and
BLUE
BLUE
LED will remain on and solid for 30 seconds only, during
www.istorage-uk.com
BLUE
LED will change to blinking
LEDs
) button for a second - the
GREEN
#21