How To Unlock With The Self-Destruct Pin; How To Configure An Admin Pin After A Brute Force Attack Or Reset - iStorage CLOUDASHUR Manuel D'utilisation

28. How to Unlock with the Self-Destruct PIN

When used, the self-destruct PIN will delete the encryption key, Admin/User PINs and then unlock the cloudAshur.
Activating this feature will cause the Self-Destruct PIN to become the New User PIN.
To activate the Self-Destruct mechanism, the cloudAshur needs to be in the standby state (solid
with the following steps.
1. In standby state (solid
down both the SHIFT (
2. Enter the Self-Destruct PIN and press the
KEY ( ) button
WARNING:

29. How to Configure an Admin PIN after a Brute Force attack or Reset

It will be necessary after a Brute Force attack or when the cloudAshur has been reset to configure an Admin PIN before the
cloudAshur can be used.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
If the cloudAshur has been brute forced or reset, the cloudAshur will be in standby state (solid
Admin PIN proceed with the following steps.
1. In Standby state (solid
down both SHIFT (
2. Enter New Admin PIN and press KEY ( )
button
3. Re-enter the New Admin PIN and press
KEY ( ) button
#24
RED LED), press and hold
) + KEY ( ) buttons
When the Self-Destruct mechanism is activated, the encryption key and the Admin/User PINs
are deleted. The Self-Destruct PIN becomes the User PIN. No Admin PIN exists after the
Self-Destruct mechanism is activated. The cloudAshur will need to be reset (see 'How to
perform a complete reset' Section 36, on page 29) first in order to configure an Admin PIN with
full Admin privileges including the ability to configure a User PIN.
RED LED), press and hold
) + 1 buttons
RED LED switches to all LEDs, RED,
BLUE
RED,
change to
on and off for a few seconds and will finally
shift to a solid
cloudAshur has successfully self-destructed
Solid
and solid
Blinking
switch to a single
back to blinking
Blinking
change to
seconds and then to a solid
ing the Admin PIN was successfully configured.
www.istorage-uk.com
RED LED) and then proceed
blinking on and off
GREEN and BLUE blinking LEDs will
GREEN and BLUE LEDs alternating
GREEN LED indicating the
RED LED). To configure an
RED LED will change to blinking
BLUE LEDs
GREEN and solid BLUE
GREEN LED blink and then
GREEN and solid
GREEN LED and solid BLUE
BLUE LED rapidly blinking for a few
BLUE
GREEN &
GREEN
LEDs will
BLUE LEDs
LED
LED indicat-