How To Perform A Complete Reset; How To Check Firmware In Admin Mode - iStorage CLOUDASHUR Manuel D'utilisation

36. How to perform a complete reset

To perform a complete reset, the cloudAshur must be in standby state (solid
Admin/User PINs and the encryption key will be deleted, leaving all associated data encrypted and inaccessible.
To reset the cloudAshur proceed with the following steps.
1. In standby state (solid
hold down "0" button
2. Press and hold down both 2 + 7 buttons
Important: After a complete reset a new Admin PIN must be configured, refer to Section 29 on page 23 on

37. How to check Firmware in Admin mode

To check the firmware revision number, first enter the "Admin Mode" as described in section 5. Once the cloudAshur is in
Admin Mode (solid BLUE
1. In Admin mode press and hold down both "3 + 8"
buttons
2. Press the KEY ( ) button once and the following happens;
a. All LEDs (RED, GREEN
b. RED LED blinks indicating the integral part of the firmware revision number.
c. GREEN LED blinks indicating the fractional part.
d BLUE LED blinks indicating the last digit of the firmware revision number
e. All LEDs (RED, GREEN
f. RED, GREEN & BLUE
For example, if the firmware revision number is '4.2', the
twice (2). Once the sequence has ended the RED,
mode, a solid BLUE LED.
#30
RED LED), press and
to Configure an Admin PIN after a Brute Force attack or
LED) proceed with the following steps.
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
LEDs switch to a solid BLUE
GREEN
RED LED). Once the cloudAshur is reset then all
Solid
GREEN
off
RED, GREEN
me solid for a second and then to a solid
LED indicating the cloudAshur has been reset
Reset'.
Solid
and BLUE
LED
RED LED will blink four (4) times and the
& BLUE LEDs will blink together once and then return to Admin
www.istorage-uk.com
RED LED will change to all LEDs, RED,
and BLUE blinking alternately on and
and BLUE alternating LEDs beco-
BLUE LED will change to blinking
LEDs
GREEN LED will blink
RED
'How
GREEN