How To Delete The User Pin Policy - iStorage CLOUDASHUR Manuel D'utilisation

Masquer les pouces Voir aussi pour CLOUDASHUR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To set a User PIN Policy, first enter the "Admin Mode" as described in section 5. Once the cloudAshur is in Admin
Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 7 buttons
2. Enter your 3 digits, remember the first two digits
denote minimum PIN length and last digit (0 or 1)
whether or not a special character has been used.
3. Press the SHIFT (
Note:
When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

9. How to delete the User PIN Policy

To delete the User PIN Policy, first enter the "Admin Mode" as described in section 5. Once your cloudAshur is in Admin
Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 7 buttons
2. Enter 070 and press SHIFT (
#12
) button once
RED
LED which then fades out to the Idle state (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle state. To unlock and access your data,
) button once
Solid
and
BLUE
Blinking
to blink
Blinking
a solid
LED indicating the User PIN Policy has been
successfully set.
BLUE
LED will remain on and solid for 30 seconds only, during
Solid
BLUE
and
BLUE
Blinking
a solid
LED indicating the User PIN Policy has been
successfully deleted
www.istorage-uk.com
BLUE
LED will change to blinking
LEDs
GREEN
and
BLUE
LEDs will continue
GREEN
and
BLUE
LEDs will change to
GREEN
LED and finally to a solid
) button for a second - the
LED will change to blinking
LEDs
GREEN
and
BLUE
LEDs will change to
GREEN
LED and finally to a solid
GREEN
BLUE
GREEN
BLUE

Publicité

Table des Matières
loading

Table des Matières