Booting From The Datashur Pro; How To Configure The Datashur Pro With Windows Os - iStorage datashur PRO Manuel D'utilisation

Instructions
1. Press and hold down number 7 (seven) button and then
press the KEY button and release buttons
(7 & )
2. Within 10 seconds begin to Press the number 9 button
three times (triple click) (999)
3. Press and hold down number 7 (seven) button and then
press the KEY button and release buttons
(7 & )

24. Booting from the datAshur PRO

iStorage datAshur PRO USB drives are equipped with a boot delay feature in order to accommodate power cycling
during a host boot process.
There may be occasions where you might want to boot from the datAshur PRO for various reasons. When booting from the
datAshur PRO, you are running your computer with the operating system that's installed on the datAshur PRO.
No special actions are required on the part of the user, and to use this feature, simply unlock the drive and connect to the USB
port of a host computer.
To force an immediate lock, always unplug to remove USB power to the datAshur PRO.

25. How to configure the datAshur PRO with Windows OS

In the event that hacking detection has been triggered by entering the incorrect PIN 10 times in succession or the drive
has been reset, all data on the drive will be lost forever. Once a New User PIN has been created, the datAshur PRO
will need to be initialised and formatted.
To initialise your datAshur PRO, do the following:
1. Create a New User PIN (see section 4).
2. Unlock the datAshur PRO by entering the New User PIN and connect to a computer's USB port.
3. The computer should notify the user with the following message:
4. Proceed by clicking on Format disk.
Select FAT32 or NTFS depending on your needs, enter a Volume Label and click Start.
LED LED State
/
Red and
Red and
/
alternately
Solid
Red LED that fades out to complete the reset
process
www.istorage-uk.com
Green LED's blink alternately
Green LED's continue to blink
Red and Green LED's change to a solid
#19