20. How to disable KeyWriter Cloning
To disable KeyWriter cloning, first enter the "Admin Mode" as described in section 5. Once the cloudAshur is in Admin
Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
'KEY ( ) + 8' buttons.
2. Enter '44' and press the 'SHIFT (
Note:
When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
21. How to check KeyWriter Cloning Configuration
To check whether the cloudAshur KeyWriter cloning is enabled or disabled, first enter the "Admin Mode" as described in
section 5. Once the cloudAshur is in Admin Mode (solid
1. In Admin mode, press and hold down both
'SHIFT (
) + 8' buttons
2. Press the KEY ( ) button and the following happens;
•
If your cloudAshur is set to enable KeyWriter cloning, the following happens;
a. All LEDs (RED,
GREEN
b.
GREEN
LED blinks once.
c. All LEDs (RED,
GREEN
d. LEDs return to solid
BLUE
•
If KeyWriter cloning is disabled, the following happens;
a. All LEDs (RED,
GREEN
b. All LEDs are off
c. All LEDs (RED,
GREEN
d. LEDs return to solid
BLUE
)' button once.
RED
LED which then fades out to the Idle state (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle state. To unlock and access your data,
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
Solid
and
BLUE
GREEN
GREEN
indicating KeyWriter cloning is disabled
BLUE
LED will remain on and solid for 30 seconds only, during
BLUE
LED) proceed with the following steps.
Solid
and
BLUE
www.istorage-uk.com
BLUE
LED will change to blinking
LEDs
and
BLUE
LEDs will change to a solid
LED and then to a solid
BLUE
) button for a second - the
BLUE
LED will change to blinking
LEDs
GREEN
LED
GREEN
#19