Deleting The One-Time User Recovery Pin; Activating Recovery Mode And Configuring New User Pin - iStorage CLOUDASHUR Manuel D'utilisation

Note: When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

17. Deleting the One-Time User Recovery PIN

To delete the One-Time User Recovery PIN, first enter the "Admin Mode" as described in section 5. Once the cloudAshur is
in Admin Mode (solid BLUE
1. In Admin mode, press and hold down both
'SHIFT ( ) + 4' buttons
2. Press and hold down both
'SHIFT ( ) + 4' buttons again
Note: When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

18. Activating Recovery Mode and configuring New User PIN

The One-Time User Recovery PIN is extremely useful in situations where a user has forgotten their PIN to unlock the
cloudAshur. To activate the recovery mode, the user must first enter the correct One-Time Recovery PIN, if one has been
configured. The user PIN recovery process does not impact the encryption key and Admin PIN, however the user is forced to
configure a new 7-15 digit User PIN.
BLUE
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To unlock and access your data,
LED) proceed with the following steps.
BLUE
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To unlock and access your data,
www.istorage-uk.com
LED will remain on and solid for 30 seconds only, during
Solid BLUE LED will change to blinking
RED LED
Blinking RED
then switch to a solid
the One-Time User Recovery PIN has been
successfully deleted
LED will remain on and solid for 30 seconds only, during
) button for a second - the
LED will become solid RED
BLUE LED indicating that
) button for a second - the
and
#17