To enter Idle State
To force cloudAshur to enter Idle State (all LEDs off), execute either of the following operations:
•
If the cloudAshur is connected to a USB port, disconnect it.
•
If the cloudAshur is not connected to a USB port, press and hold down the SHIFT (
the LED turns solid
Power-on States
After the cloudAshur wakes from Idle State, it will enter one of the three possible states shown in the table below.
Power-on State
LED indication
RED
Standby
Reset
RED
RED
Low Battery Level
Times
Note: When your cloudAshur is unlocked and not connected to a USB port and no operations are performed
within 30 seconds, the cloudAshur will enter Idle State automatically. The LED turns to solid
then fades out.
When connected to a powered USB port, a locked cloudAshur will start charging after 30 seconds,
indicated by a blinking
When the cloudAshur is unlocked and connected to a USB port, it will not accept further instructions
via the keypad.
RED
and fades out to the Idle State (off).
Encryption
Key
Solid
Solid
Blinks 3
BLUE
LED.
Admin
Description
PIN
Waiting for Admin or User PIN entry
Waiting for configuration of an Admin PIN
Charge on a powered USB port for 15-30 minutes
www.istorage-uk.com
) button for a second until
RED
and
#7