Adding A New User Pin In Admin Mode; Changing The User Pin In Admin Mode - iStorage CLOUDASHUR Manuel D'utilisation

11. Adding a New User PIN in Admin Mode

PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• The SHIFT ( ) button can be used for additional PIN combinations - e.g. SHIFT (
than just 1. See section 8, 'Setting a User PIN Policy'.
To add a New User PIN, first enter "Admin Mode" as described in section 5. Once the cloudAshur is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
'KEY ( ) + 3' buttons
2. Enter New User PIN and press KEY ( ) button
3. Re-enter the New User PIN and press KEY ( )
button
Note: When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

12. Changing the User PIN in Admin Mode

To change an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the cloudAshur is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
'KEY ( ) + 3' buttons
2. Enter New User PIN and press KEY ( ) button
3. Re-enter the New User PIN and press KEY ( )
button
#14
BLUE
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To unlock and access your data,
www.istorage-uk.com
Solid BLUE LED will change to blinking
and solid BLUE
Blinking GREEN
switch to a single
back to blinking
Blinking GREEN
to a rapidly blinking
solid BLUE LED indicating a New User PIN has
been successfully configured
LED will remain on and solid for 30 seconds only, during
Solid BLUE LED will change to blinking
and solid BLUE
Blinking GREEN
switch to a single
back to blinking
Blinking GREEN
to a rapidly blinking
a solid BLUE
been successfully changed
) + 1 is a different value
GREEN
LEDs
and solid BLUE LEDs will
GREEN LED blink and then
GREEN and solid BLUE
and solid BLUE LEDs change
GREEN LED and finally to a
) button for a second - the
GREEN
LEDs
and solid BLUE LEDs will
GREEN LED blink and then
GREEN and solid BLUE
and solid BLUE LEDs change
GREEN LED and finally to
LED indicating the User PIN has
LEDs
LEDs