Instructions
1. Press and hold down number 7 (seven) button and then
press the KEY
button and release buttons
(7 &
)
2. Within 10 seconds begin to Press the number 9 button
three times (triple click) (999)
3. Press and hold down number 7 (seven) button and then
press the KEY
button and release buttons
(7 &
)
24. Booting from the datAshur Personal
iStorage datAshur Personal
during a host boot process.
There may be occasions where you might want to boot from the datAshur Personal
the datAshur Personal
, you are running your computer with the operating system that's installed on the datAshur Personal
2
No special actions are required on the part of the user, and to use this feature, simply unlock the drive and connect to the USB
port of a host computer.
To force an immediate lock, always unplug to remove USB power to the datAshur Personal
25. How to configure the datAshur Personal
In the event that hacking detection has been triggered by entering the incorrect PIN 10 times in succession or the drive
has been reset, all data on the drive will be lost forever. Once a New User PIN has been created, the datAshur
Personal
will need to be initialised and formatted.
2
To initialise your datAshur Personal
1. Create a New User PIN (see section 4).
2. Unlock the datAshur Personal
3. The computer should notify the user with the following message:
4. Proceed by clicking on Format disk.
Select FAT32 or NTFS depending on your needs, enter a Volume Label and click Start.
USB drives are equipped with a boot delay feature in order to accommodate power cycling
2
, do the following:
2
by entering the New User PIN and connect to a computer's USB port.
2
LED
LED State
/
Red
and
Red
and
/
alternately
Solid
Red
LED that fades out to complete the reset
process
2
2
www.istorage-uk.com
Green
LED's blink alternately
Green
LED's continue to blink
Red
and
Green
LED's change to a solid
for various reasons. When booting from
2
.
2
with Windows OS
.
2
#19