How To Set Your Cloudashur To Enable Keywriter Cloning - iStorage CLOUDASHUR Manuel D'utilisation

To activate the Recovery process and configure a new User PIN, proceed with the following steps.
1. With the cloudAshur in Idle State, press and hold
down the SHIFT (
2. In Standby State, press and hold down both
'KEY ( ) + 4' buttons
3. Enter the One-Time Recovery PIN and press the
KEY ( ) button
4. Enter the New User PIN and press the KEY ( )
button
5. Re-enter the New User PIN and press the
KEY ( ) button again
Important: The creation of a new User PIN must comply with the 'User PIN Policy' if one has been configured
as described in section 8, which imposes a minimum PIN length and whether a special character has been
used. Refer to section 10 to check the user PIN restrictions.

19. How to set your cloudAshur to enable KeyWriter Cloning

Note: The cloudAshur is set as default to enable cloning by the KeyWriter.
The cloudAshur can be used in conjunction with the iStorage KeyWriter to enable cloning of up to 9 devices at a time. To
enable the cloudAshur to be cloned by the KeyWriter, first enter the "Admin Mode" as described in section 5. Once the
cloudAshur is in Admin Mode (solid
1. In Admin mode, press and hold down both
'KEY ( ) + 8' buttons.
2. Enter '11' and press the 'SHIFT (
Note: When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
#18
) button for one second
BLUE LED) proceed with the following steps.
)' button once.
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To unlock and access your data,
RED,
sequence then the
finally switches to a solid
the cloudAshur is in Standby State
Solid
GREEN
GREEN
to a solid
GREEN
Blinking
a single
GREEN
GREEN
GREEN
been successful and a new user PIN configured
Solid
and BLUE
GREEN
GREEN
indicating the cloudAshur is set to enable
KeyWriter cloning
BLUE LED will remain on and solid for 30 seconds only, during
www.istorage-uk.com
GREEN and BLUE LEDs blink once in
GREEN LED blinks twice and
RED LED indicating
RED LED will change to blinking
LEDs
and BLUE LEDs alternate on and off then
GREEN LED and finally to blinking
and solid BLUE LEDs
GREEN and solid BLUE
GREEN LED blink then back to blinking
and solid BLUE LEDs
LED blinks rapidly then becomes solid
indicating the recovery process has
BLUE LED will change to blinking
LEDs
and BLUE LEDs will change to a solid
LED and then to a solid BLUE
) button for a second - the
RED and
LEDs change to
GREEN
LED