How To Check Firmware In User Mode - iStorage CLOUDASHUR Manuel D'utilisation

Note: When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

38. How to check Firmware in User Mode

To check the firmware revision number, first enter the "User Mode" as described in section 14. Once the cloudAshur is in
User Mode (solid GREEN
1. In User mode press and hold down both "3 + 8"
buttons until GREEN and
2. Press the KEY ( ) button and the following happens;
a. All LEDs (RED, GREEN
b. RED LED blinks indicating the integral part of the firmware revision number.
c. GREEN LED blinks indicating the fractional part.
d BLUE LED blinks indicating the last digit of the firmware revision number
e. All LEDs (RED, GREEN
f. RED, GREEN & BLUE LEDs switch to a solid
For example, if the firmware revision number is '4.2', the
twice (2). Once the sequence has ended the RED,
mode, a solid GREEN LED.
Note: When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To unlock and access your data,
LED) proceed with the following steps.
BLUE LEDs blink together
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
BLUE
GREEN
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To unlock and access your data,
BLUE LED will remain on and solid for 30 seconds only, during
Solid
GREEN
LED
RED LED will blink four (4) times and the
& BLUE LEDs will blink together once and then return to the User
BLUE LED will remain on and solid for 30 seconds only, during
www.istorage-uk.com
) button for a second - the
GREEN LED will change to blinking
and BLUE LEDs
GREEN LED will blink
) button for a second - the
#31