Changing The Admin Pin - iStorage diskAshur DT2 Guide De Démarrage Rapide

Changing the Admin PIN

PIN Requirement
• PINs must be a minimum length of 7 and maximum 15 digits.
• Cannot contain all sequenital numbers (2345678 or 9876543).
• Cannot contain all repeating numbers (1111111).
• The SHIFT key can be used for additional combinations (e.g. SHIFT+1 is a separate
value to just 1).
To change the Admin PIN to your own unique 7-15 digit PIN, follow the steps below.
1. In Standby State (solid RED
press and hold down both the 'UNLOCK
and number '1' buttons.
2. Enter your Admin PIN (default
'11223344') and press the 'UNLOCK'
button.
3. In Admin mode (solid BLUE
and hold down 'UNLOCK + 2' buttons.
4. Enter your NEW Admin PIN and press
'UNLOCK' button.
5. Re-enter your NEW Admin PIN and
press 'UNLOCK' button.
6. To exit Admin Mode press the 'LOCK'
button.
LED),
Solid
BLUE
GREEN
few seconds then to a solid
BLUE
Mode'.
LED), press Solid
solid
Blinking
a single
GREEN
Blinking
to a rapidly blinking
solid
successfully changed.
Solid
the standby state.
RED LED will change to blinking
LEDs
and BLUE LEDs blink rapidly together for a
GREEN
LED indictaing the diskAshur DT
BLUE LED will change to blinking
BLUE LEDs.
GREEN and solid BLUE LEDs will switch to
GREEN LED blink and then back to blinking
and solid BLUE LEDs.
GREEN and solid BLUE LEDs change
BLUE LED and finally to a
BLUE LEDindicating the Admin PIN has been
RED LED indicates the drive is locked and in
GREEN and
and finally a solid
is in 'Admin
2
GREEN and
5