Note:
When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
22. How to disable the cloudAshur Client Application Registration
The cloudAshur is configured so that it cannot be registered by the client application when it is shipped from factory or
completely reset. The client application feature is automatically enabled when the initial Admin PIN is changed or when a
User PIN is configured or changed.
To disable client application registration, first enter the "Admin Mode" as described in section 5. Once the cloudAshur is in
Admin Mode (solid
BLUE
1. In Admin mode, press and hold down both
'3 + 7' buttons.
2. Press the KEY ( ) button once.
Note:
When the cloudAshur is in Admin Mode, the
which time the cloudAshur can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the cloudAshur will exit Admin mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
your cloudAshur must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
23. How to check whether Client Application Registration is enabled
To check whether the cloudAshur client application registration is enabled, first enter the "Admin Mode" as described in
section 5. Once the cloudAshur is in Admin Mode (solid
#20
RED
LED which then fades out to the Idle state (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle state. To unlock and access your data,
LED) proceed with the following steps.
RED
LED which then fades out to the Idle state (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle state. To unlock and access your data,
www.istorage-uk.com
BLUE
LED will remain on and solid for 30 seconds only, during
Solid
BLUE
and
BLUE
GREEN
GREEN
indicating the client application registration is
disabled
BLUE
LED will remain on and solid for 30 seconds only, during
BLUE
LED) proceed with the following steps.
) button for a second - the
LED will change to blinking
LEDs
and
BLUE
LEDs will change to a solid
LED and then to a solid
BLUE
) button for a second - the
GREEN
LED