Table des Matières
Publicité
EC240000
CABLE ROUTING DIAGRAM
1 Fuel tank breather hose
2 Cable guide
3 Throttle cable
4 Clamp
5 Clutch cable
6 Wireharness
7 "ENGINE STOP" button lead
8 CDI unit
9 CDI unit stay
0 CDI unit band
q TPS (throttle position sensor)
lead
w Solenoid valve lead
e Air vent hose (left)
r Transmission oil breather hose
t Overflow hose
y Air vent hose (right)
CABLE ROUTING DIAGRAM
A Pass the fuel tank breather hose
between the handlebar and ten-
sion bar, then insert its end into
the hole of the number plate.
B Pass the throttle cable and
"ENGINE STOP" button lead into
the cable guide. Align with the
cable guide the front end of the
tape on the throttle cable.
C Pass the throttle cable and
"ENGINE STOP" button lead
over the radiator hose.
D Clamp the throttle cable and
"ENGINE STOP" button lead with
the clamp ends downward.
E Pass the clutch cable a little for-
ward of the extreme left nut that
holds the cylinder head.
F Pass the wireharness between
the engine brackets.
2-13
SPEC
G Pass the air vent hoses, overflow
hose and transmission oil
breather hose between the frame
and connecting rod.
H Fit the CDI unit band into the CDI
unit stay till it stops.
I Insert the CDI unit into the CDI
unit band till it stops.
J Clamp the TPS (throttle position
sensor) lead and solenoid valve
lead at the side of the TPS with
the clamp ends backward.
K Clamp the air vent hoses.
L Pass the air vent hoses, overflow
hose and transmission oil
breather hose so that all these
hoses do not contact the rear
shock absorber.
Publicité
Table des Matières
