Yamaha YZ250/LC Manuel Du Propriétaire page 442

FRONT FORK
4. Tighten:
9
Pinch bolt (handle crown) 1
9
Pinch bolt (under bracket) 2
cC
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
9
Brake hose holder 1
9
Caliper 2
9
Bolt (caliper) 3
NOTE:
Fit the brake hose holder cut a over the projec-
tion b on the front fork and clamp the brake
hose.
6. Install:
9
Brake hose holder 1
9
Bolt (brake hose holder) 2
9
Protector 3
9
Bolt (protector) 4
NOTE:
When installing the brake hose holder, align the
top a of the brake hose neck with the brake
hose holder bottom b. Then pass the brake
hose 5 in front of the axle boss c and fit it into
the hose groove d so that the brake hose does
not contact the nut (wheel axle).
7. Adjust:
9
Rebound damping force
NOTE:
Turn in the damping adjuster 1 finger-tight and
then turn out to the originally set position.
5-39
CHAS
23 Nm (2.3 m•kg, 17 ft•lb)
20 Nm (2.0 m•kg, 14 ft•lb)
23 Nm (2.3 m•kg, 17 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)