Yamaha YZ250/LC Manuel Du Propriétaire page 362

TRANSMISSION, SHIFT CAM AND SHIFT FORK
2. Install:
9
2nd wheel gear (25 T) 1
9
4th wheel gear (24 T) 2
9
3rd wheel gear (23 T) 3
9
5th wheel gear (20 T) 4
9
1st wheel gear (27 T) 5
9
O-ring 6
To drive axle 7.
NOTE:
9
Apply the molybdenum disulfide oil on the 1st,
2nd and 3rd wheel gears inner circumference
and on the end surface.
9
Apply the molybdenum disulfide oil on the 4th
and 5th wheel gears inner circumference.
9
Apply the lithium soap base grease on the O-
ring.
3. Install:
9
Plain washer 1
9
Circlip 2
NOTE:
9
Be sure the circlip sharp-edged corner a is
positioned opposite side to the plain washer
and gear b.
9
Be sure the circlip end c is positioned at axle
spline groove d.
4. Install:
9
Spacer 1
NOTE:
9
Apply the lithium soap base grease on the oil
seal lip.
9
When installing the spacer into the crankcase,
pay careful attention to the crankcase oil seal
lip.
9
Install the spacer with its chamfered side a
facing the crankcase.
4-75
ENG