Table des Matières
Publicité
TPS (THROTTLE POSITION SENSOR) SYSTEM
3
Y L
B
1
4
2
2
4. Install:
9
TPS 1
9
Screw (TPS) 2
NOTE:
9
Align the slot a in the TPS with the projection
b on the carburetor while the lever 3 is held
down.
9
Temporarily tighten the screws (TPS).
5. Install:
9
Mixing chamber top
9
Carburetor
Refer to "CARBURETOR AND REED
VALVE" section in the CHAPTER 4.
6. Adjust:
9
Idle speed for TPS adjustment
Adjustment steps:
9
Set
the
inductive
tachometer) to the high tension cord.
9
Turn the throttle stop screw 1 until the
specified idle speed.
Refer to "IDLE SPEED ADJUSTMENT" sec-
tion in the CHAPTER 3.
Idle speed for TPS adjustment:
1,700~1,900 rpm
7. Insert the thin electric conductors 2 (lead
wire) into the TPS coupler 1, as shown,
and connect the tester to them.
Tester (+) lead ¡Yellow lead 3
Tester (–) lead ¡Black lead 4
cC
9
Do not insert the electric conductors
more than required because it may
reduce the waterproof function of the
coupler.
9
Make sure that a short-circuit does not
develop between the terminals because it
may cause damage to electrical compo-
nents.
6-11
ELEC
tachometer
(engine
Publicité
Table des Matières
