Preparatory Work Before Installation; Fixing To Parapet Or Ceiling Mount - Videotec Série 2 Manuel D'instructions

6.5 Preparatory work before
installation
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
Use appropriate tools for the installation.
The particular nature of the site where the
device is to be installed may mean special
tools are required for installation.
Choose an installation surface that is
strong enough to sustain the weight of
the device, also bearing in mind particular
environmental aspects, such as exposure to
strong winds.
It should be installed so that no one can be
hit by moving parts. It should be installed
so that moving parts cannot hit other
objects and create hazardous situations.
Make sure the appliance is securely
anchored before supplying power.
For technical services, consult only and
exclusively authorized technicians.
Since the user is responsible for choosing
the surface to which the unit is to be
anchored, we do not supply the fixing
devices for attaching the unit firmly to
the particular surface. The installer is
responsible for choosing fixing devices
suitable for the specific purpose on hand.
It is possible to install the unit with several brackets.
We strongly recommend using only approved
brackets and accessories during installation.
MNVCNXPTZ2_2032_EN

6.5.1 Fixing to parapet or ceiling mount

For ceiling assembly, the Ceiling Assembly
mode must be enabled using the web
interface (Web Interface manual, Motion
Parameters Page).
Fix the adaptor (01) to the bottom of the unit using
the 4 flat countersunk screws (02) with hexagonal
socket M10x20mm in stainless steel (A4 class 70)
supplied.
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270) into the threaded holes in
the base of the device.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
01
Fig. 6
Use the external holes in the adapter to fix the
assembled unit to the parapet or to the ceiling. Use
screws that can bear at least 4 times the weight of
the unit.
Fig. 7
02
Ø 238
15