Installation Instructions - ST Quadrat LUX-top KLICK II Mode D'emploi

Installation instructions

NOTES:
 Before installation,
respective substrate/surface is suitable for fixing
the anchor device and has sufficient load-bearing
capacity.
 Each anchor
installation with a
point! To do this, after inserting the anchor
eyebolt in the respective anchor sleeve, always
check whether the green check ring on the
release pin is visible.
1. Installation of the anchor sleeve on concrete structures:
1.1 Installation with bonded anchor sleeve.
Installation characteristics
Minimum concrete quality (strength class):
Minimum thickness of structural member:
Drillhole diameter:
Minimum anchored depth:
Minimum distance from the edge:
Maximum anchor sleeve protrusion above the concrete:
Always contact the manufacturer in case of different basic conditions!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.st-quadrat.lu
always ensure
sleeve must be checked
®
LUX-top KLICK II
Page 7 Version 05/2015
that the
after
anchor
1. Make drillhole (∅ 28 mm) in the concrete
structural member.
2. Use a blow pump to blow out or rather clean the
hole.
3. Use a special brush to clean the drillhole
thoroughly!
4. Blow out again.
After blowing out the hole again, the drillhole must be
completely free from drilling dust residues!
5. Inject the supplied
withdrawing the gun nozzle continuously.
6. Insert the anchor
movement, until it is flush with the front edge of
the member. A small amount of bonding
compound must emerge at the drillhole.
The anchor sleeve must never jump back behind
the finished structure (note any plaster/render
layers, etc.)!
7. Leave to cure - ready!
C20/25
120 mm
28.0 mm
80.0 mm
120 mm
920 mm
bonding compound by
sleeve with a rotary