Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Installation of the anchor sleeve on load-bearing masonry:
The load-bearing capacity of the masonry must be checked and confirmed on site.
3.1 Installation with anchor sleeve and load spreading washers, bolted onto masonry
Installation characteristics
Load-bearing capacity / stability
Minimum thickness of structural member:
Drillhole diameter:
Maximum anchor sleeve protrusion above the masonry:
Always contact the manufacturer in case of different basic conditions!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.st-quadrat.lu
to be verified on site!
240 mm
26.0 mm
To be checked individually
Page 11 Version 05/2015
1.
Make drillhole Ø 26 mm in masonry.
2.
Insert anchor sleeve in the drillhole
and attach load spreading washers
on both sides.
3.
Use the two M24 nuts to bolt and
lock
the
anchor
sleeve,
orientated. The anchor sleeve must
not sit low in the respective nut on
both sides, but must at least end
flush! If continuous vibrations are
expected, additional (high-strength)
liquid thread locker must be used!
anchor-
Publicité
Table des Matières
