ST Quadrat LUX-top KLICK II Mode D'emploi page 18

 The anchor device may only be used for attaching the PFPE (personal fall protection
equipment) to EN 363, consisting, for example of a full body harness (EN 361), lanyard
(EN 354) and energy absorber (EN 355). Alternatively, use a restraint system to EN 358!
 If the anchor device is used as part of a fall arrest system the user must be equipped with
an energy absorber, which limits the maximum dynamic forces that act on the user during
an arrest to 6 kN maximum.
 By combining individual elements of the named equipment, hazards can occur as the safe
function of one of the elements can be impaired. Therefore, always ensure that the
equipment parts put together to form a system are compatible with each other.
 The components of the personal protective equipment against falls from a height must be
checked to ensure that they are in proper condition and that they comply with these user
instructions.
 The user must visually inspect the anchor device before each use to ensure its proper
functional and maintained condition.
 The relevant national regulations and the health & safety regulations (in Germany the
accident prevention regulations of the trade associations responsible for industrial safety)
and any other relevant regulations must be complied with when using the
KLICK II system. For Germany these include, among other things:
 TRBS 2121 "Technische Regeln für Betriebssicherheit -
Technical rules for health & safety at work - risk to people due to falling
 DIN 4426 "Sicherheitstechnische Anforderungen an Arbeitsplätze + Verkehrswege" /
Safety requirements for workplaces and transport routes
 DIN 363 "Persönliche Absturzschutzausrüstung – Persönliche Absturzschutzsysteme" /
Personal fall protection equipment - personal fall protection systems
 BGV C22 "Bauarbeiten" / Construction work
 BGR 198 "Einsatz von persönlicher Schutzausrüstung gegen Absturz" / Use of personal
protective equipment against falls from a height
 BGR 203 "Dacharbeiten" / Roof work
 BGI 5164 „Planungsgrundlagen
principles for anchor devices on roofs
 Ensure safe, stable position during use!
 A plan must exist, which takes into account the rescue measures for all possible
emergency incidents that can occur.
 Should any doubt occur regarding safe condition (e.g. severe corrosion, deformations) or
following a fall of a person secured on the
withdrawn from further use, it must be inspected by a competent person.
 After a fall the stability of the surface/substrate to which the equipment is attached must
be checked before re-installing a new anchor device.
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.st-quadrat.lu
von Anschlageinrichtungen
LUX-top
Page 3 Version 05/2015
Gefährdung von Personen durch Absturz" /
auf Dächern"/Planning
®
KLICK II, the system must be
®
LUX-top