Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Installation of the anchor sleeve on steel structures:
Installation characteristics
Minimum steel grade:
Minimum thickness of structural member:
Drillhole diameter:
Maximum anchor sleeve protrusion above the steel
structure:
Always contact the manufacturer in case of different basic conditions!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.st-quadrat.lu
1.
Make drillhole Ø 26 mm in the steel structure and
coat with suitable rustproofing agent.
2.
Use the two M24 nuts to bolt and lock the anchor
sleeve on the steel structure, anchor-orientated.
The anchor sleeve must not sit low in the
respective nut on both sides, but must at least
end flush!
If continuous vibrations are expected, additional
(high-strength) liquid thread locker must be used!
S235
6.00 mm
26.0 mm
250 mm
Page 10 Version 05/2015
Publicité
Table des Matières
